Juniper QFabric QFX3008-I, Manual, Page: 134 / 472

of a link or activity on the port and the port status. See “Network Module Port LEDs on a
QFX3100 Director Device” on page 383 .
Table 31 on page 108 provides the pinout information for the network module’s RJ-45
connector.
Table 31: Network Port Connector Pinout Information for a QFX3100 Director Device
Description Signal Pin
Transmit/receive data pair 1 TRP1+ 1
Transmit/receive data pair 1 TRP1- 2
Transmit/receive data pair 2 TRP2+ 3
Transmit/receive data pair 3 TRP3+ 4
Transmit/receive data pair 3 TRP3- 5
Transmit/receive data pair 2 TRP2- 6
Transmit/receive data pair 4 TRP4+ 7
Transmit/receive data pair 4 TRP4- 8
Related
Documentation
Front Panel of a QFX3100 Director Device on page 26
•
Interface Specifications for SFP+ Transceivers for QFX3500 Device Access Ports
Access ports in QFX3500 devices support SFP and SFP+ transceivers. This topic describes
the optical interfaces supported for those transceivers. It also specifies the copper
interface supported for the SFP transceivers.
CAUTION: Do not place a copper transceiver in an access port directly above
or below another copper transceiver. Internal damage to the access ports
and device can occur. Because of this limitation, a maximum of 18 copper
transceivers can be installed in ports
6
through
41
. We recommend using only
the top row of access ports for copper transceivers.
NOTE: Use only transceivers purchased from Juniper Networks for your QFX
Series device.
The optical transceivers installed in QFX3500 devices support digital optical monitoring
(DOM): you can view the diagnostic details for these transceivers by issuing the operational
Copyright © 2012, Juniper Networks, Inc. 108
QFX3000 Hardware Documentation