Juniper NFX150, Hardware Manual

Page: 67 / 152

Figure 21: Attaching Antennas to NFX150-C-S1-AA and NFX150-C-S1-AE
g100054
See Also Connecting Earth Ground to an NFX150 Device on page 73
•
•
Connecting AC Power to an NFX150 Device on page 75
•
Clearance Requirements for Airflow and Hardware Maintenance for an NFX150 Device
on page 45
Mounting an NFX150 Device on a Wall
You can mount an NFX150 device on a wall by using the separately orderable wall-mount
kit.
Before mounting an NFX150 device on a wall:
• Verify that the site meets the requirements described in “Site Preparation Checklist
for NFX150 Devices” on page 41 .
•
Read “General Safety Guidelines and Warnings” on page 117 , with particular attention
to “Chassis Lifting Guidelines for NFX150 Devices” on page 123 .
• Remove the device from the shipping carton (see “Unpacking an NFX150 Device” on
page 61 ).
Ensure that you have the following parts and tools available:
• Phillips (+) screwdriver, number 2
•
2 wall-mount brackets (provided with the wall-mount kit)
•
8 wall-mount bracket screws (provided with the wall-mount kit)
• 4 mounting screws (8-32 x 1.25 in. or M4 x 30 mm) (not included)
• Hollow wall anchors capable of supporting the weight of a fully loaded NFX150 device,
up to 9 lb (4 kg) (not included)—if you are mounting the device in sheetrock (wall
board with a gypsum plaster core) or in wall board not backed by wall studs
67 Copyright © 2018, Juniper Networks, Inc.
Chapter 3: Initial Installation and Configuration