Juniper NFX150, Hardware Manual

Page: 104 / 152

Figure 47: Inserting a Fiber-Optic Cable into a Transceiver on an NFX150-C-S1 Device
g100028
See Also Disconnecting a Fiber-Optic Cable from an NFX150 Device on page 101
•
•
Maintaining Fiber-Optic Cables in an NFX150 Device on page 101
Removing the NFX150 Device from a Rack or Cabinet
•
Powering off an NFX150 Device on page 104
•
Removing an NFX150 Device from a Rack or Cabinet on page 106
Powering off an NFX150 Device
To power off the NFX150 device, follow the procedure in this topic.
Before you power off the switch:
•
Ensure that you understand how to prevent electrostatic discharge damage. See
“Prevention of Electrostatic Discharge Damage” on page 142 .
• Ensure that you do not need to forward traffic through the device.
Ensure that you have the following parts and tools available to power off the switch:
• An electrostatic discharge (ESD) grounding strap
• An external management device such as a PC
•
A cable to connect the external management device to the console port (CON) or
management port (MGMT) on the device
To power off the device:
1.
Connect the management device (such as a PC) to the console (CON) port or the
management (MGMT) port on the device:
• For connecting a management device to the console port, see “Connecting an
NFX150 Device to a Management Console” on page 78 .
•
For connecting a management device to the management port, see “Connecting
an NFX150 Device to a Network for Out-of-Band Management” on page 77
2.
From the PC connected to the device, issue the following operational mode CLI
command:
Copyright © 2018, Juniper Networks, Inc. 104
NFX150 Network Services Platform Hardware Guide