Juniper NETSCREEN-ISG 2000, User Manual, Page: 8 / 114

Preface
2 User’s Guide
C
OMMAND
L
INE
I
NTERFACE
(CLI) C
ONVENTIONS
The following conventions are used when presenting the syntax of a command line
interface (CLI) command:
• Anything inside square brackets [ ] is optional.
• Anything inside braces { } is required.
• If there is more than one choice, each choice is separated by a pipe ( | ). For
example,
set interface { ether1/1 | ether1/2 | ether2/2 } manage
means “set the management options for the ether1/1, ether1/2, or ether2/2
interface”.
• Variables appear in italic. For example:
set admin user name1 password xyz
When a CLI command appears within the context of a sentence, it is in bold (except for
variables, which are always in italic ). For example: “Use the get system command to
display the serial number of a NetScreen device.”
J
UNIPER
N
ETWORKS
N
ET
S
CREEN
P
UBLICATIONS
To obtain technical documentation for any Juniper Networks NetScreen product, visit
www.juniper.net/techpubs/ .
For technical support, open a support case using the Case Manager link at http://
www.juniper.net/support/ or call 1-888-314-JTAC (within the United States) or 1-408-745-
9500 (outside the United States).
If you find any errors or omissions in the following content, please contact us at the e-mail
address below:
techpubs-comments@juniper.net
Note: When typing a keyword, you only have to type enough letters to identify the word
uniquely. For example, typing set adm u joe j12fmt54 is enough to enter the command
set admin user joe j12fmt54 . Although you can use this shortcut when entering
commands, all the commands documented here are presented in their entirety.