Juniper MX2010, Hardware Manual

Page: 740 / 825

RELATED DOCUMENTATION
MX2010 Modular Port Concentrator Description | 70
Maintaining MX2010 MICs | 651
Maintaining Cables That Connect to MX2010 MPCs or MICs | 607
Replacing an MX2010 MIC | 515
Troubleshooting the MX2010 MPCs
Problem
Description: The following LEDs indicate a problem with an MPC:
•
The red FAIL LED above the MPC is lit.
•
The green OK LED above the MPC is not lit.
Solution
To troubleshoot an MPC:
1. Monitor the green LED labeled OK above the MPC on the craft interface as soon as an MPC is seated
in an operating router.
NOTE: The Control Board and Routing Engine (CB-RE) downloads the software to the
MPC under two conditions: The MPC is present when the CB-RE boots Junos OS, and
the MPC is installed and requested online through the CLI or the push button on the front
panel. The MPC then runs diagnostics, during which the OK LED blinks. When the MPC
is online and functioning normally, the OK LED lights green steadily.
2. Look at the display on the craft interface to check the status of the MPC and the MICs that are plugged
into it.
3. Verify that the MPC is properly seated in the top and bottom backplanes of the adapter card (ADC).
Check that each knob has been turned clockwise and is tight.
4. Check the OK/FAIL LED on the MPC, and the OK and FAIL line-card LEDs, LC0 through LC9, on the
craft interface. When the MPC is online and functioning normally, the OK LED lights green steadily.
5. Check the status of an MPC by using the show chassis fpc CLI command. As shown in the sample
output, the value Online in the column labeled State indicates that the MPC is functioning normally:
726