Juniper MX2010, Hardware Manual

Page: 63 / 825

CHAPTER 4
Cable and Rack Management
IN THIS CHAPTER
MX2010 Cable Manager Description | 37
MX2010 Rack-Mounting Hardware | 43
MX2010 Cable Manager Description
IN THIS SECTION
Standard Cable Manager | 37
Extended Cable Manager | 40
The MX2010 router supports the following cable managers:
Standard Cable Manager
The standard cable manager consists of the following components:
•
Card-cage cable manager and air filter—MX2000-CBL-MID
•
Lower cable manager—MX2000-CBL-BTM-S
•
DC power cable manager—MX2010-DC-CBL-MGR-S
The lower cable manager (see Figure 11 on page 38 ) is located just below the bottom line-card cage, has
a removable cover that is secured by two captive screws with access to rows used for routing and securing
the cables away from the front of the Modular Port Concentrators (MPCs), and Modular Interface Cards
(MICs) (see Figure 12 on page 39 ).
You can use cable strips or other ties to gently secure the cables in the lower cable manager. To secure
the cables in place, loop the tie through the cable anchor and secure the tie.
37