Juniper MX2010, Hardware Manual

Page: 461 / 825

•
Press the online/offline button on the MIC. Use a narrow-ended tool that fits inside the opening
that leads to the button. Press and hold the button until the MIC LED goes off (about 5 seconds).
•
Issue the following CLI command:
user@host>
request chassis mic fpc-slot
fpc-slot
mic-slot
mic-slot
offline
For more information about the command, see the Junos OS System Basics and Services Command
Reference .
3. Unplug the cable from the cable connector port. If the MIC uses fiber-optic cable, immediately cover
each transceiver and the end of each cable with a rubber safety cap.
WARNING: Do not look directly into a fiber-optic transceiver or into the ends
of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable connected
to a transceiver emit laser light that can damage your eyes.
CAUTION: Do not leave a fiber-optic transceiver uncovered except when
inserting or removing cable. The safety cap keeps the port clean and prevents
accidental exposure to laser light.
4. Remove the cable from the cable manager, and detach it from the destination port.
SEE ALSO
Installing a Cable on an MX2010 MPC or MIC | 445
Preventing Electrostatic Discharge Damage to an MX Series Router
Installing a Cable on an MX2010 MPC or MIC
To install a MIC cable or an MPC cable (see Figure 212 on page 446 and Figure 213 on page 447 ):
1. Have ready a length of the type of cable used by the component. For cable specifications, see the MX
Series Interface Module Reference .
2. If the cable connector port is covered by a rubber safety cap, remove the cap.
445