Juniper MX2010, Hardware Manual

Page: 446 / 825

Replacing an MX2010 Three-Phase Wye AC Power Cord | 583
Replacing an MX2020 Three-Phase Wye AC Power Distribution Module | 590
Tools and Parts Required for Replacing MX2010 Hardware Components
To replace hardware components, you need the tools and parts listed in Table 94 on page 430 .
Table 94: Tools and Parts Required for Component Replacement
Tool or Part Components
Electrostatic discharge (ESD) grounding wrist strap All
Phillips (+) screwdrivers, number 1 and 2 AC power supply module
Phillips (+) screwdriver, number 2 to access the metal
AC wiring compartment
7/16-in. (11 mm) hexagonal-head external drive socket
wrench, or nut driver, with a torque range between
23 lb-in. (2.6 Nm) and 25 lb-in. (2.8 Nm) to attach the
ground wire.
1/4-in. slotted screwdriver and 5/32-in. (4 mm) Allen
wrench to attach input terminal wires of the AC power
cord.
AC power distribution module
Three-phase delta AC PDM
Three-phase wye AC PDM
Phillips (+) screwdrivers, numbers 1 and 2
7/16-in. (11 mm) hexagonal-head external drive socket
wrench, or nut driver, with a torque range between
23 lb-in. (2.6 Nm) and 25 lb-in. (2.8 Nm) to attach the
ground wire.
1/4-in. slotted screwdriver and 5/32-in. (4 mm) Allen
wrench to attach input terminal wires of the AC power
cord.
AC power cord
Phillips (+) screwdrivers, numbers 1 and 2 Craft interface
430