Juniper MX2010, Hardware Manual

Page: 358 / 825

Connecting MPC or MIC Cables to the MX2010 Router | 348
Connecting an MX2000 Router to a Console or Auxiliary Device | 338
Connecting the MX2010 Router to a Network for Out-of-Band Management | 337
CB-RE and RCB Interface Cable and Wire Specifications for MX Series Routers | 155
Connecting the MX2010 Router to a Network for Out-of-Band Management
To connect the CB-RE to a network for out-of-band management, connect an Ethernet cable with RJ-45
connectors to the MGMT port on the CB-RE interface. One Ethernet cable is provided with the router.
To connect to the MGMT port on the CB-RE interface:
1. Turn off power to the management device.
2. Plug one end of the Ethernet cable ( Figure 139 on page 338 shows the connector) into the MGMT port
on the CB-RE interface. Figure 138 on page 338 shows the port. Table 84 on page 338 describes the
Ethernet ports.
3. Plug the other end of the cable into the network device.
Figure 143: Out-of-Band Management Port
g007007
1 2 3
Figure 144: Out-of-Band Management Cable Connector
Table 87: Out-of-Band Management Port on the MX2010 CB-RE
Description Label Function No.
Dedicated management channel for device
maintenance. It is also used by system
administrators to monitor and manage the
MX2010 remotely.
MGMT 3
342