Juniper MX2010, Hardware Manual

Page: 180 / 825

Table 49: RJ-45 Connector Pinout for the AUX and CONSOLE Ports (continued)
Description Signal Pin
Receive Data RXD 6
Data Set Ready DSR/DCD 7
Clear to Send CTS 8
RJ-45 Connector Pinouts for an MX Series CB-RE or RCB Management
Port
The port on the Control Board and Routing Engine (CB-RE; Routing and Control Board (RCB)) labeled
MGMT is an autosensing 10/100/1000-Mbps Ethernet RJ-45 receptacle that accepts an Ethernet cable
for connecting the Routing Engine to a management LAN (or other device that supports out-of-band
management).
NOTE: In routers where the Routing Engine and Control Board (CB) are integrated into a single
board, a CB-RE is known as Routing and Control Board (RCB). The RCB is a single FRU that
provides Routing Engine and CB functionality.
Table 50 on page 158 describes the RJ-45 connector pinout.
Table 50: RJ-45 Management Port Connector Pinouts for the CB-RE or RCB MGMT Port
Description Signal Pin
Transmit/receive data pair 1 TRP1+ 1
Transmit/receive data pair 1 TRP1– 2
Transmit/receive data pair 2 TRP2+ 3
Transmit/receive data pair 3 TRP3+ 4
Transmit/receive data pair 3 TRP3– 5
Transmit/receive data pair 2 TRP2– 6
158