Juniper MX10008, Hardware Manual

Page: 261 / 361

Figure 155: Adding Handle Extensions
g100210
4. Tighten the screws into the handle extensions.
5. Snap open the blue clips on the ends of the cable tray with your hands.
6. Place the cable tray across the front of the line card so that the two ends of the cable tray are under
the handle extensions.
7. Snap close the blue clips of the cable tray around the handle extensions (see Figure 156 on page 263 ).
Figure 156: Adding the Cable Tray
g100209
8. Drape the optical cables using one of the following methods:
•
Drape and tie the optical cables to the side (see Figure 157 on page 264 ).
263