Juniper LN1000 - RELEASE NOTES 8-27-2010, User Manual

Page: 55 / 64

Filesystem cleanup skipped - NVMRO Read-only
Loading configuration ...
....
No files are deleted when NVMRO is set to
Read-only
regardless of the
fs_clean_boot
setting.
After the system completes its boot process, you can review the list of removed files by
reading the
file_cleanup.log
file:
root@ln1000%
cat /var/tmp/file_cleanup.log
/cf/var/log/appidd
/cf/var/log/bin_messages
/cf/var/log/chassisd
/cf/var/log/cosd
/cf/var/log/dcd
.....
/cf/var/tmp/policy_status
/cf/var/tmp/rtsdb/if-rtsdb
/cf/var/tmp/spu_kmd_init
/cf/var/tmp/vpn_tunnel_orig.id
root@ln1000%
To determine the value of the fs_clean_boot environmental variable using the CLI:
root@ln1000% sysctl kern.fs_clean_boot
kern.fs_clean_boot: 1
root@ln1000%
Removing Temporary IDP Package Installation Files
The
fs_clean_boot
option does not remove temporary files left over from the IDP security
package installation. To remove the temporary files, run the separate IDP cleanup request
after installing or upgrading the IDP package:
user@ln1000>
request security idp storage-cleanup downloaded-files
Successfully deleted downloaded secdb files
user@ln1000>
Related
Documentation
Powering On the LN1000 Mobile Secure Router on page 25
•
•
SPOST and POST Diagnostic Tests on page 35
•
LN1000 Router Power Requirements on page 13
Accessing the Extended Diagnostic Tests
From the bootstrap prompt, you can enter the Diagnostic CLI menu interface and navigate
through the interface to execute diagnostic commands. Otherwise, you can use command
scripting at the bootstrap prompt.
The Diagnostic CLI menu interface combines all diagnostic tests and flags into a menu
structure that is easy to navigate and provides access to all available diagnostic
commands. You enter the Diagnostic CLI menu interface from the bootstrap prompt,
BOOT>, by entering the
diags
command.
41
Chapter 8: Troubleshooting Router Boot-Up and Operation