Juniper LN1000 - RELEASE NOTES 8-27-2010, User Manual

Page: 25 / 64

Table 4: Pinouts for the RJ-45 (NPU), shMM, and IPMC Console Port Connectors (continued)
Description Setting Pin
No connect. NC 7
No connect. NC 8
IPMI Shelf Manager
The optional IPMI shelf management module provides intelligent management functions
for the rear transition module, including sensing the presence of the LN1000 router, and
configuring and booting the router when it is installed in the LN1000 rear transition module.
NOTE: The IPMI shelf manager is not installed in the LN1000 rear transition
module by default.
The IPMI shelf manager:
•
Is implemented as a Small Outline Dual Inline Memory Module (SODIMM) form factor
•
Is installed in a board-mounted SODIMM connector on the LN1000 rear transition
module
• Complies with the PICMG 3.0 R2.0 and IPMI v1.5 and implements the IPMI v1.5
functionality on the LN1000 rear transition module
•
Communicates with the IPMI controller on the LN1000 router
LN1000 Rear Transition Module Ethernet Ports
The LN1000 rear transition module includes eight gigabit Ethernet ports to provide
Ethernet connectivity. These eight ports connect directly to the chassis midplane, enabling
you to connect directly to the Ethernet ports on the LN1000 router. Ethernet Port 0 is
typically used as the management port. Ports 1 through 7 are typically used for data
transfer.
NOTE: There is no dedicated management port on the LN1000 router.
LN1000 Rear Transition Module Switch Settings
The switch banks on the rear transition module are set as follows:
Description Switch Bank
No user control. All switches are off for normal operation. S1
11
Chapter 2: LN1000 Rear Transition Module Overview