Juniper Junos Space JA1500, Hardware Manual

Page: 54 / 210

To connect AC power to the Junos Space Appliance, do the following:
1.
(Optional) Attach an electrostatic discharge (ESD) grounding strap to your bare wrist
and connect the strap to an external ESD point.
2.
Ensure that the power supply module is fully inserted into the chassis.
3.
Squeeze the two sides of the power cord retainer clip and insert the L-shaped ends
of the wire clip into the holes in the bracket on each side of the AC power cord inlet
on the faceplate of the AC power supply module, as shown in
Figure 9 on page 40 .
Figure 9: Connecting an AC Power Supply Module
4.
Locate the power cord or cords shipped with the appliance; the cords have plugs
appropriate for your geographical location
WARNING: Ensure that the power cord does not block access to appliance
components or drape where people can trip on it.
5.
Insert the coupler end of the power cord into the AC power cord inlet on the faceplate
of the AC power supply module.
6.
Push the cord into the slot in the adjustment nut of the power cord retainer. Turn the
nut until it is tight against the base of the coupler and the slot in the nut is turned 90°
from the top of the appliance, as shown in
Figure 9 on page 40 .
7.
If the AC power source outlet has a power switch, set it to the OFF position.
8.
Insert the power cord plug into an AC power source outlet.
9.
If the AC power source outlet has a power switch, set it to the ON position.
Copyright © 2018, Juniper Networks, Inc. 40
JA2500 Junos Space Appliance Hardware Guide