Juniper JRR200, Hardware Manual

Page: 44 / 108

3.
Place the grounding cable lug over the grounding point on the rear of the chassis.
NOTE: The JRR200 route reflector should be permanently connected to
ground during normal operation. A licensed electrician must attach a cable
lug to the grounding cable. A cable with an incorrectly attached lug can
damage the JRR200 route reflector.
4.
Secure the grounding cable lug to the grounding point with the screw.
5.
Dress the grounding cable and ensure that it does not touch or block access to other
device components and that it does not drape where people could trip over it.
Connecting Power to an AC-Powered JRR200 Route Reflector
Ensure that you have a power cord appropriate for your geographical location available
to connect AC power to the JRR200 Route Reflector. Before you begin connecting AC
power:
•
Ensure that you have taken the necessary precautions to prevent electrostatic discharge
(ESD) damage.
• Ensure that you have connected the device chassis to earth ground.
CAUTION: Before you connect power to the JRR200 route reflector, a
licensed electrician must attach a cable lug to the grounding cable that
you supply. A cable with an incorrectly attached lug can damage the device
(for example, by causing a short circuit).
To meet safety and electromagnetic interference (EMI) requirements and
to ensure proper operation, you must properly ground the JRR200 route
reflector chassis before connecting power.
Copyright © 2018, Juniper Networks, Inc. 44
JRR200 Route Reflector Hardware Guide