Configuring the IP Address and Domain Name Servers
To configure the JATP network settings, enter the values for the following parameters:
NOTE: Use the up or down arrow keys to navigate the fields.
1. Enter the IP address of the management interface (eth0).
2. Enter the network mask address for the eth0 interface.
3. Enter the default gateway for the eth0 interface.
4. Enter the primary DNS server for the eth0 interface.
5. (Optional) Type Yes and enter the secondary DNS server for the eth0 interface.
6. (Optional) Type Yes and enter the search domain for the eth0 interface. For example, example.com.
NOTE: Provide a space to enter multiple search domains.
7. Type Yes and press Enter to restart the management (eth0) interface.
NOTE: The network interface restart can take up to 60 seconds or more.
Configuring the Device Host Name
To configure the device host name:
1. Enter a valid hostname. For example, JATP400.
NOTE: Enter a unique name for the host and do not include the domain.
Updates server to JATP400.example.com.
41
Summary of Contents for JATP400
