Juniper JATP400, Hardware Manual

Page: 34 / 113

2. Remove the JATP400 appliance and all items from the shipping container. See, "Unpacking the
JATP400" on page 27 .
3. Verify that all parts have been received. See, "Verifying the JATP400 Parts Received" on page 27 .
Unpacking the JATP400
Gather the tools required to unpack the JATP400 appliance:
• Phillips (+) screwdriver, number 1
• Phillips (+) screwdriver, number 3
TIP: Save the shipping materials in case you need to move or ship the device later.
NOTE: Do not unpack the device until you are ready to begin installation.
To unpack the JATP400:
1. Move the cardboard carton to a staging area as close to the installation site as possible, where you
have enough room to remove the components from the chassis.
2. Position the cardboard carton with the arrows pointing up.
3. Carefully open the top of the cardboard carton.
4. Remove the foam covering the top of the JATP400 appliance.
5. Remove the accessory box.
6. Verify the parts received against the lists in "Verifying the JATP400 Parts Received" on page 27 .
Verifying the JATP400 Parts Received
The JATP400 appliance shipment package contains a packing list. Check the parts in the shipment
against the items on the packing list. The packing list specifies the part numbers and carries a brief
description of each part in your order.
If any part on the packing list is missing or damaged, contact your customer service representative or
contact Juniper customer care from within the U.S. or Canada by telephone at 1-888-314-5822. For
27