Juniper J4350, Getting Started Manual

Page: 101 / 284

Chapter 6
Installing and Connecting a Services
Router
Make the appropriate preparations and verify the J-series equipment before
installing a J-series Services Router and connecting it to a power source and the
network.
This chapter contains the following topics:
Before You Begin on page 81
Unpacking a J-series Services Router on page 82
Installing a J4350 and J6350 Services Router on page 83
Connecting Interface Cables to a Services Router on page 85
Chassis Grounding on page 86
Connecting Power on page 86
Powering a Services Router On and Off on page 90
Before You Begin
Before you begin installation, complete the following tasks:
Read the information in “Maintenance and Operational Safety Guidelines
and Warnings” on page 231, with particular attention to “Chassis Lifting
Guidelines” on page 221.
Determine where to install the Services Router, and verify that the rack or
installation site meets the requirements described in “Preparing for Router
Installation” on page 71.
For installation, gather the following equipment and tools: mounting brackets
and screws (provided), number 2 Phillips screwdriver, and mounting screws
appropriate for your rack.
To connect the router to power and ground, have ready a 14 AWG grounding
cable and lug, as specified in “Chassis Grounding” on page 86, and the power
Before You Begin
81