Steps to Deploy a New IDP 8200 with New I/O Modules
1
Installing IDP 8200 I/O Modules
Date
: June 27, 2008
Revision
00
This document provides instructions for installing IDP 8200 I/O modules.
Follow the workflow that applies to the stage of your deployment:
“Steps to Deploy a New IDP 8200 with New I/O Modules” on page 1
“Steps to Add or Replace I/O Modules in a Deployed IDP 8200” on page 3
1
Steps to Deploy a New IDP 8200 with New I/O Modules
When your Juniper Networks shipment arrives, it includes an IDP 8200 chassis with
4 blank I/O module trays installed. Separately, your shipment might include one or
more installable I/O module trays.
To install the I/O module hardware, follow these steps:
1.
Install the IDP appliance in your equipment rack and connect the power supply,
as described in Chapter 4 of the
Juniper Networks Intrusion Detection and
Prevention Installation Guide.
2.
Power off the device. Verify that the POWER LED is off.
3.
Unscrew the I/O module blank tray and remove it from the chassis.
Figure 1: Identifying the I/O Module Blank Tray
4.
Carefully replace the blank tray with the new I/O module tray.
CAUTION:
Carefully observe safety guidelines provided in the
Juniper Networks
Intrusion Detection and Prevention Installation Guide.
I/O Module
Blank Tray