Juniper EX9208, Hardware Manual, Page: 376 / 396

If no grounding strap is available, touch the exposed, bare metal of the device to ground
yourself before handling the component.
• Avoid contact between the component that is subject to ESD damage and your clothing.
ESD voltages emitted from clothing can damage components.
•
When removing or installing a component that is subject to ESD damage, always place
it component-side up on an antistatic surface, in an antistatic card rack, or in an
antistatic bag (see
Figure 99 on page 352 ). If you are returning a component, place it in
an antistatic bag before packing it.
Figure 99: Placing a Component into an Antistatic Bag
6xGE
SFP
0
1
2
3
4
5
CAUTION
ELECTROSTATIC
SENSITIVE
DEVICES
DO NOT OPEN OR HANDLE
EXCEPT AT A
STATIC-FREE WORKSTATION
CAUTION: ANSI/TIA/EIA-568 cables such as Category 5e and Category 6
can get electrostatically charged. To dissipate this charge, always ground
the cables to a suitable and safe earth ground before connecting them to the
system.
Related
Documentation
See General Safety Guidelines and Warnings on page 317 .
•
•
See EX2200 Switches Hardware Overview for the ESD point location.
•
See Rear Panel of an EX3200 Switch for the ESD point location.
•
See Rear Panel of an EX3300 Switch for the ESD point location.
•
See Rear Panel of an EX4200 Switch for the ESD point location.
•
See EX4300 Switches Hardware Overview for the ESD point location.
•
See Front Panel of an EX4500 Switch for the ESD point location.
•
See EX4550 Switches Hardware Overview for the ESD point location.
•
See Chassis Physical Specifications of an EX6210 Switch for the ESD point location.
•
See Chassis Physical Specifications of an EX8208 Switch for the ESD point location.
•
See Chassis Physical Specifications of an EX8216 Switch for the ESD point location.
•
See EX9204 Switch Hardware Overview for the ESD point location.
Copyright © 2017, Juniper Networks, Inc. 352
EX9208 Switch Hardware Guide