Juniper EX4600, Hardware Manual

Page: 177 / 230

CHAPTER 18
Performing Initial Configuration
• Configuring an EX4600 Switch on page 159
Configuring an EX4600 Switch
You must perform the initial configuration of the EX4600 switch through the console
port using the command-line interface (CLI).
Before you begin connecting and configuring an EX4600 switch, set the following
parameter values on the console server or PC:
• Baud Rate—9600
• Flow Control—None
•
Data—8
•
Parity—None
• Stop Bits—1
• DCD State—Disregard
To connect and configure the switch from the console:
1.
Connect the console port to a laptop or PC using the supplied RJ-45 cable and RJ-45
to DB-9 adapter. The console (
CON
) port is located on the management panel of the
switch.
2.
Log in as root . There is no password. If the software booted before you connected to
the console port, you might need to press the Enter key for the prompt to appear.
login: root
3.
Start the CLI.
root@% cli
4.
Enter configuration mode.
root> configure
5.
Add a password to the root administration user account.
[edit]
root@#
set system root-authentication plain-text-password
New password:
password
Retype new password: password
159 Copyright © 2014, Juniper Networks, Inc.