Juniper CTP2000 Series, Hardware Manual

Page: 95 / 149

WARNING: For the larger CTP series devices, three people are required to install the
device in a rack: two to lift the device into position and one to screw it to the rack.
To unpack the device:
1. Cut the two straps that secure the carton to the skid, open the carton from the top, and remove the
box of accessories that sits on top of the device.
2. Unlock the four plastic clips that hold the box to the skid by squeezing them in their center and pulling
out, and then lift the carton off the device.
3. Remove the three screws that attach each of the two L-brackets to the device.
4. To avoid scratching the device when removing it from the skid, detach one of the L-brackets from the
skid by removing the three screws.
RELATED DOCUMENTATION
Before You Unpack the CTP Platform | 87
Inspecting Platform Components and Accessories | 88
If You Detect or Suspect Damage | 89
Contacting Juniper Networks | 89
Inspecting Platform Components and Accessories
After you remove the equipment from the shipping containers:
•
Confirm the contents of each container.
•
Inspect all external surfaces and external connectors for visible signs of damage.
•
Inspect all accessories shipped with each unit.
•
Document any damage noted during your inspection.
•
Confirm that the platform has the correct number and type of modules for your ordered configuration.
88