Juniper CTP151 Platform, Hardware Manual, Page: 80 / 104

Using SSH to Access the CTP151 Device
After you have configured an IP address for the CTP151 device, you can run SSH from a remote host to
access the device through its Ethernet port. To connect the Ethernet port to the network:
1. Connect an Ethernet RJ-45 cable to the Ethernet port on which you configured the IP address on the
front panel of the CTP151 chassis.
2. Connect the other end of the cable to the appropriate Ethernet network for an out-of-band connection.
CAUTION: Do not change the IP address for the Ethernet interface that you are using
to communicate with the device. If you change the address, you will lose the SSH
session.
RELATED DOCUMENTATION
Using HyperTerminal to Access the CTP151 Device | 73
Bringing Up the CTP151 with CTPOS on Internal SSD | 76
Configuring the First Boot Script for the CTP151 Device | 77
74