Juniper BXOS 4.1 R2, Release Note

Page: 12 / 24

BXOS 4.1 R2 Software Release Notes
12 „
Outstanding Issues
„ When you test an MLPPP interface based on the testing methods described in
the RFC 2544, the test for zero packet loss fails over the MLPPP interface.
There is no workaround. [PR/441052]
„ The gateway does not support the loopback address configuration for ATM
OAM. There is no workaround. [PR/442888]
„ SNMP community configuration is lost when you upgrade the BXOS software.
There is no workaround. [PR/445085]
„ The BXOS software does not support a separate command to view the static
route configuration. As a workaround, use the
show configuration command to
view all the static routes configured on the gateway. [PR/446239]
„ If the system is in a continuous loop state, you can recover the system but you
will lose the existing configuration. [PR/446191]
To recover the system from a continuous loop:
1. Reboot the system.
The prompt displays:
Applying configuration. Press Ctrl+C to exit...
.
2. Press
Ctrl+C
to interrupt the startup process.
The prompt displays:
BX7000 login:
3. Enter the login username and password as root.
BX7000 login: root
Password:
The prompt displays
:
root@BX7000#
4. Delete the
startup.cfg
file using the
rm
command:
root@BX7000# rm /config/startup.cfg
5. Reboot the system using the following command:
root@BX7000# reboot
The system reboots after several seconds and the existing configuration is
lost.
6. After the system reboot, access the gateway using the root account or CLI
user privileges.
To log in as a root user, type the login username and password as root.
BX7000 login: root
Password:
The prompt displays:
root@BX7000
or
To log in as a CLI user, type the login username and password as cli.
BX7000 login: cli
Password:
The prompt displays:
cli@BX7000>