T-27 Tucano 20cc 1.2 2022
5
DISCLAIMER
In Brazil, model airplane activity for recreational purposes is regulated by ANAC (National Civil
Aviation Agency) through the Special Brazilian Civil Aviation Regulation RBAC-E No. 94 that entered
into force on July 1, 2021, or subsequent substitutive document.
Important information is contained in subparts
E94.3 Definitions; E94.103 General rules for the
operation of unmanned aircraft; E94.301 Registration and cadastre and E94.501 General
provisions.
The Ministry of Defense, Aeronautics Command, Department of Air Space Control regulates the
procedures and responsibilities necessary for access to Brazilian Air Space by unmanned aircraft
with use exclusively for recreation, the so-called model aircraft through the
MCA 56-2
manual that
entered into force on July 1, 2020, or subsequent substitutive document.
The radio control equipment used in model airplanes, according to the General
Telecommunications Law (Law nº 9.472, of July 16, 1997) must be approved through a certification
issued or accepted by ANATEL (National Telecommunications Agency). Information about this
procedure can be obtained from the Certification and Numbering Management
–
ORCN ANATEL or
by e-mail: [email protected].
We recommend reading the documents cited for legal information about the operation of your
model aircraft and the use of Brazilian airspace. For residents in other countries, we recommend
researching local legislation, regulations and safety recommendations. Also look for FAI - World
Airsports Federation
All images, drawings and photos are for illustrative purposes only. Appearance and features of
the product depend on how it is assembled or used by the user. All specifications, features and
models described and shown are subject to change without notice.
Kit contents:
We recommend checking all items when you receive your model aircraft. Your T-27 Tucano 20cc Juniaer
consists of the following items:
1 instruction manual containing disclaimer
1 left wing
1 fuselage
1 set of left-wing landing gear doors
1 set of front landing gear doors
1 right wing
1 upper engine cowling with 4 screws
1 set of right-wing landing gear doors
1 lower engine cowling
1 aluminum tube diameter 25.4 mm
1 rudder
1 set of clear lenses
3 pin hinges for rudder
2 pitot tubes replicas
1 fuselage side door
2
¼” x ¾” Allen screws for wing attachment
1 fuselage side door hinge
2
washers ¼” for wing attachment
1 spring latch for fuselage side door
1 stabilizer
1 cockpit
1 laser cut plywood servo tray
1 canopy frame
1 laser cut plywood tank tray
1 clear canopy
