Jungheinrich ERC 212, Operating Instructions Manual

Page: 77 / 125

75 75
0 0
3 3
. .
1 1
1 1
E E
N N
Setting the travel program configuration to a Setting the travel program configuration to a code code
Procedure Procedure
•• Pr Pres ess t s the he O k O key ey (6 (68) 8)..
•• En Ente ter th r the ma e mast ster c er cod ode. e.
•• Enter Enter the t the three-d hree-digit igit parame parameter n ter number umber 024. 024.
•• Con Confir firm wi m with t th the S he SET k ET key ( ey (69) 69)..
•• Enter Enter the co the code to de to be cha be changed a nged and con nd confirm w firm with SE ith SET. T.
•• Enter t Enter the conf he configurat iguration (4 d ion (4 digit) a igit) and conf nd confirm wit irm with SET. h SET.
•• Enter t Enter the conf he configurat iguration (4 d ion (4 digit) a igit) again an gain and confi d confirm wit rm with SET. h SET.
•• Rep Repeat th eat the proc e procedu edure for o re for othe ther code r codes. s.
•• Th Then en pr pres ess t s the he O k O key ey..
The travel programs are assigned to the codes The travel programs are assigned to the codes
Keypad error messages Keypad error messages
LED (70) flashes red to indicate the following errors: LED (70) flashes red to indicate the following errors:
– – New master code is already in use. New master code is already in use.
– – New code is already the master code New code is already the master code
– – Code to be changed does not exist Code to be changed does not exist
– – Attempt to change the code to one that already exists. Attempt to change the code to one that already exists.
– – Attempt to delete a code that does not exist Attempt to delete a code that does not exist
– – Code memory full. Code memory full.
https://www.besttruckmanuals.com/