digital audio
modular
processing system
C8000
16 channel DSP
C8092
page
10/24
RESET
Restart Module
Pressing <RESTART> performs a warm start (soft reset)
Initialize and Restore
Pressing <INITIALIZE> restores the factory default values for all
Factory Defaults
parameters of the module including all presets. You will lose
your presets and settings. It's highly recommended to backup the
settings and presets to a PC first.
BACKUP / RESTORE
Backup Settings and
Pressing <BACKUP> will put all active parameters and the
Presets to File
content of all presets into an XML file.
You may store such file on a PC.
Restore Settings and
You may browse a matching XML file from a PC.
Presets from File
Pressing <RESTORE> will overwrite all active parameters and the
content of the presets with the content from the backup file.
ROUTING
The bus interface allows for very flexible interconnection from and to the c8k audio busses, either in
two channel or eight channel multiplex mode. The inputs to the DSPs (Ch 01/02 … Ch 15/16) exclude
each other (see example below). You can select a specific DSP input pair from the c8k bus either in
2ch [S1 … S4] or eight channel [S5] mode. When you select an input bus that is fed up-stream
in 8ch mode [S5] you must also select a signal pair from that bus [Ch1/2, Ch3/4, Ch5/6] for a dedicated
DSP input:
Similar applies to the output routing. [S9] is fed in 8Ch and [S10] in fed 2Ch mode.
Duplicated busses [S11] are marked red as a warning because the signal will be disturbed if you
connect two outputs [Ch 01/02, Ch 09/10] to the same bus.
