Temperature Management
Room temperature controller
Ref.-no.: TR..231.., TR..241..,
TR..236.., TR..246..
2
Fig.
c
3. Connection
1. Carry out the electrical connection according to the respective wiring
diagram (Fig. (2) or Fig. (3).
Note:
Ensure that the neutral conductor N is connected to terminal N.
Considerable fluctuations in temperature may otherwise occur. Conductor
cross-section: 1 to 2.5 mm2 solid conductor.
Symbols used in the wiring diagram:
L
= L conductor
N
= N- conductor
= Connection for clock signal to reduce temperature
=
Heating
=
Cooling
RF
= Resistor for thermal feedback
TA
= Resistor for night reduction of room temperature
2. Clip the rocker (
A
in Fig.
c
) on the switch in the flush insert.
3. Place the center plate together with the frame on the flush insert. The
center plate must snap in place in the top left of the housing base.
4. Tighten the screw (
B
).
5. Clip on the setting knob (
C
).
