After 4 hours the motion detector switches to automatic mode.
Operating mode: switch light off for 4 hours
o
Press installation button 3 x.
Light switches off for 4 hours.
The red LED lights up.
After 4 hours the motion detector switches to automatic mode.
Operating mode: switch on test operation
o
Press installation button 4 x.
The red and green LEDs light up.
The test mode is active. Each time motion is detected, the motion detector switches on for
approx. 3 seconds independently of the brightness.
The yellow LED lights up briefly each time a motion is detected.
Performing a reset
o
Press installation button longer than 4 seconds.
A reset is performed. The motion detector is in automatic mode.
Configuring the motion detector
The three adjusters can be used to set the run-on time, the brightness, the sensitivity and a
short-time operation.
picture 4
Set follow-up time
The light remains switched on for this time after the last movement detection. The run-on time is
set in a range from approx. 2 seconds to 30 minutes.
o
Turn the
time
adjuster (7) to the required position (picture 4).
i
The motion detector switches off after 90 minutes at the latest even when there is constant
motion in the detection area. Switch-on only takes place again if the brightness is below the
preset value and there movement is again detected in the detection area.
Setting the brightness threshold
Only when the brightness drops below the threshold will the light be switched on when there is
motion in the detection area. The brightness threshold is steplessly adjustable in a range from
approx. 1 to 1000 lux.
4/15
32536423
J:0082536423
26.07.2010
Observer 220
