Jung KNX 5178TSM-01 Series, Operating Instructions Manual

Page: 5 / 6

i If the device does not receive any application software, or the wrong application software,
then the top Status LEDs flash slowly blue and red.
Figure
4
: Activating programming mode
o Activate programming mode: Press and hold push­button at the upper left (12). Then press
push­button at the lower right (13).
The top Status LEDs (LED 1 and LED 2) flash quickly blue and red.
o Load the physical address into the device.
The LEDs return to their previous state – off, on, or flashing slowly.
o Write the physical address on the device label.
o Load the application software into the device.
Installing the buttons
The buttons are available as a complete set of buttons (see accessories).
o Place the buttons on the device in the correct orientation and snap in with a short push.
6 Appendix
Disposal
Please consider your local regulation for disposal and electronic waste recycling.
6.1 Technical data
KNX medium TP
Commissioning mode S-mode
Rated voltage KNX DC 21 ... 30 V SELV
Current consumption KNX
without TSEM
max. 15 mA
with TSEM max. 20 mA
Connection mode KNX device connection terminal
Ambient temperature 23 ... 113 °F
(-5 ... +45 °C)
Storage/transport temperature -13 ... +158 °F
(-25 ... +70 °C)
Protection class III
Connection of the extension module
Number
1
Cable length 100 ft (30 m)
Cable type Use only cables which are approved for KNX.
5/6
Room temperature controller module 2-gang
32589705
J0082589705
28.06.2017