o
Assign physical address.
The red LED goes out.
o
Write the physical address on the device label.
o
Load the application program into the device.
i
In case of active temperature measurement ("Universal" version) compare the temperature
measurement.
Testing the detection area
In the case of main units and extensions, check the detection areas of the devices individually.
Precondition: The device is installed and connected. The physical address is loaded.
o
Activate the walking test:
Activate the parameter "Walking test after ETS programming" and download the
application software.
The device now operates brightness-independently. The PIR sensors are active according
to their programmed sensitivity.
o
Pace off the detection field, paying attention to reliable detection and interference sources.
Any motions detected are displayed by the blue LED.
o
Limit the detection area as required. Adjust sensitivity with adjuster
Sens.
or IR remote
control, or change the programming.
o
Deactivate the parameter "Walking test after ETS programming" and download the
application software.
Only for "Universal" version:
i
If enabled, the walking test function can be activated with the button
Test
of the IR remote
control.
7 Appendix
7.1 Technical data
Commissioning mode
S-mode
Current consumption KNX
3 ... 10 mA
Ambient temperature
-25 ... +55 °C
Storage/transport temperature
-25 ... +70 °C
Relative humidity
10 ... 100 % (No moisture condensation)
Protection class
III
Installation height
1.10 / 2.20 m
Detection angle
180 °
Detection field (mounting at 2.20 m)
Tangential movements
approx. 12 x 12 m
Radial movememtns
approx. 8×8 m
Detection field (mounting at 1.10 m)
Tangential movements
approx. 6 x 6 m
Radial movememtns
approx. 4×4 m
Brightness sensor
Measuring range
approx. 1 ... 1000 lx
Temperature sensor
Measuring range
approx. -20 ... +55 °C
Accuracy
± 1 K
7.2 Accessories
IR remote control
Art. No. KNXPMFBIR
Sealing kit for automatic switch 180° 2.20 m
8/9
32597103
j0082597103
30.05.2017
Standard / Universal automatic switch 2.2 m