© JUNG Hebe- und Transporttechnik GmbH
Electrically driven trolleys JLA-e 5/12 G with stroke and JLA-e 15/30 G with stroke
Engl
ish
- 64 -
8. Care and maintenance
NOTE
According to DGUV regulation 68, you, as the owner of
this trolley, are responsible for the annual maintenance
and inspection.
WARNING
There is a risk of crushing when servicing a trolley.
Always wear protective clothing, otherwise injuries may
occur.
7.1 Greasing the bearings
NOTE
Regularly grease the bearings since they are subjected
to strong friction forces. Use commercially available
high-performance bearing grease.
> Use a paintbrush to grease the bearings.
> Grease the bearings of the trolley at least once a
year.
7.2 Checking the oil
> Loosen screws (1) and remove the cover (2).
> The oil should reach as far as the marking (3).
> To refill oil, screw off the lid (4).
7.3 Maintenance of the toothed chain
The intended service life of the toothed chains is only
reached through regular care and maintenance.
Care and maintenance intervals vary significantly,
depending on use and degree of contamination.
Make sure that lubricating oil is used according to the
lubricant recommendations.
Recommended: NOW chain and wire rope spray, art.
no. 95 050 200-E.
The toothed chain must be examined regularly for
wear. Damaged chain links or worn sprockets must be
replaced!
7.4 Repair
Necessary repairs are carried out by JUNG according
to a cost estimate, at short notice and at a reasonable
price. Contact details can be found on the back of the
operating instructions.
1
1
1
2
M+P-44A-0165
4
3
M+P-44A-0167
