Radio push-button controller for rail mounting
Radio Management
Radio push-button controller for rail mounting
Art.-No.: FST 1240 REG
Operationsmanual
1 Safety instructions
Electrical equipment may only be installed and fitted by electrically skilled persons.
Failure to observe the instructions may cause damage to the device and result in fire and
other hazards.
Danger of electric shock. Always disconnect before carrying out work on the devise or
load. At the same time, take into account all circuit breakers that supply dangerous
voltage to the device or load.
Danger of electric shock. Device is not suitable for disconnection from supply voltage.
These instructions are an integral part of the product, and must remain with the end
customer.
2 Device components
picture 1
(1) Control unit
(2) Programming button
(3) Programming LED
(4) Connection terminal for bus cable
3 Function
Intended use
-
Radio-controlled switching and brightness setting for lamp operating devices with 1-10 V
interface
-
Operation with suitable radio transmitters in combination with a radio receiver RMD
-
Installation in distribution boxes on DIN rail according to DIN EN 60715
i
It is not possible to teach a combination of presence detector and motion detector.
Product characteristics
-
Switch-on brightness can be saved permanently
-
Light scene operation possible
1/5
32550213
J:0082550213
29.07.2010
