5.2 Commissioning
Setting the brightness and switch-on time
Figure 9: Adjuster
(10) Brightness adjuster
(11) Switch-on time adjuster
(12) Rotary switch programming mode
PROG
o
Slacken the two screws (5) and remove housing lid (4) (figure 1).
o
Turn brightness adjuster (10) to the desired value (figure 9).
Recommendation: A setting of 10 lux activates the device at the start of twilight.
o
Turn switch-on time adjuster (11) to the desired value (figure 9). The switch-on time can be
set from approx. 10 seconds to approx. 15 minutes.
Teaching a radio transmitter
When teaching a radio transmitter, the sensitivity of the power pack is reduced to about 5 m.
The distance between the power pack and the transmitter being taught should therefore be
between 0.5 m and 5 m.
o
Slacken the two screws (5) and remove housing lid (4) (figure 1).
o
Turn rotary switch
PROG
(12) to
ON
to activate the programming mode (figure 9).
The red LED flashes.
o
Trigger a teach telegram with the radio transmitter being taught (see instructions for radio
transmitter).
When the power pack receives the radio telegram, the green and red LEDs light up.
The connected load is switched on.
o
Turn rotary switch
PROG
(12) to
OFF
to exit the programming mode.
The green and red LEDs go out.
The load is switched off, the power pack is in normal operation.
The radio transmitter has been taught.
i
After a radio motion detector has been taught, it may still be in walking test mode, and
switches the lighting on briefly every time a motion is detected (see radio motion detector
instructions).
i
If all 30 memory slots of the power pack are occupied, a radio transmitter which has
already been taught must first be deleted.
7/9
32529813
J0082529813
02.11.2016
Radio Management
Radio performance unit
