Connecting and mounting the device
picture 2
(1) DALI potentiometer "Active mode"
(6) DALI subscriber e. g. DALI electrical ballast
(7) DALI potentiometer without connection of mains voltage "Passive mode"
o
Connect the DALI potentiometer and DALI electrical ballast according to the wiring
example (picture 2). In so doing, observe the data of the electrical ballast manufacturer.
o
When switch multiple DALI potentiometers, ensure correct polarity.
o
If multiple miniature circuit breakers supply dangerous voltages to the device or load,
couple the miniature circuit breakers or label them with a warning, to ensure release is
guaranteed.
i
Ensure that the control cable is of the appropriate type, cross-section and routing for the
VDE specifications for 250 V cable, control voltage has basic insulation.
i
The control cable and load cable can be run in a shared cable, e.g. NYM J 5×1.5.
i
The connected DALI subscribers may be operated on different phases.
5.2 Commissioning
Saving a basic brightness
The basic brightness should be a state when turning the DALI potentiometer does not directly
lead to an increase in brightness.
o
Switch the lighting on minimum brightness.
o
Turn the DALI potentiometer to the point that where the brightness begins to increase.
o
Press the control knob for longer than 10 seconds.
The lighting switches briefly off and on again. The basic brightness is saved.
i
Any basic brightness can be saved from which it is possible to add brightness.
Deleting the basic brightness
o
Switch the lighting off.
o
Press the control knob for longer than 10 seconds.
Briefly switch the lighting to maximum brightness and then off again. The basic brightness
has been deleted.
i
DALI subscribers of different manufacturers may deviate from the acknowledgements
given here.
3/4
82563213
J:0082563213
06.05.2010
Power DALI potentiometer insert
