Jung 3361-1AL-01, Operating Instructions Manual

Page: 4 / 12

10 SEK , 30 SEK , 2 MIN , 5 MIN , 30 MIN Function block 1: Extend minimum run­on­time
(10 seconds) by the selected value
START , STOP Function block 1: Extend minimum run­on­time
(10 seconds) individually
Set-up buttons, IR remote control
Button Function
Ù Walking test – Check detection field
Ú Reset sensitivity, brightness threshold and
run­on­time to presetting. Press for at least 3
seconds
Operation with IR remote control
If enabled, function block 1 can be operated manually by remote control. In manual operation,
brightness and motion detection for function block 1 are switched off until automatic mode is
reset.
o Switch on, e.g. light: Press ¿ button.
o Switch off, e.g. light: Press Á button.
o Set automatic mode: Press À button.
Manually change settings with IR remote control
If enabled, individual settings for function block 1 can be changed during operation using a
remote control.
Sensitivity:
o Increase sensitivity: Press ´ button.
o Decrease sensitivity: Press ² button.
o Recall set sensitivity: Press ³ button.
i The manual adjustment of sensitivity by the adjuster Sens. (6) is overwritten by the IR­
remote control and vice versa.
Brightness threshold:
o Change brightness threshold: Depending on requirement, press Ê button, Ë button, Ì
button or Í button.
o Set current brightness as brightness threshold: Press É button.
Run­on­time: The preset run­on­time of 10 seconds can be extended individually.
o Extend run­on­time: Depending on requirement, press 10 SEK button, 30 SEK button, 2
MIN button, 5 MIN button or 30 MIN button. Other values can be set with the START / STOP
buttons.
4/12
Presence detector
82585625
J0082585625
04.12.2017