LB management
Brightness / temperature sensor Bluetooth
Figure 5: Engaging the circuit board
￭
Note MAC address (3) (Figure 5). This address is required for assignment to the cover.
￭
Insert the circuit board in the housing base. Firstly, push the circuit board up to the front
side of the housing and then push the rear section of the circuit board downwards
(Figure 5).
Figure 6: Close housing
￭
Reattach the housing lid and push the housing together until it locks into place. (Figure 6).
The device is ready for operation.
Assigning the sensor to the cover
The sensor transmits the brightness and temperature values every 5 minutes and when the
brightness or temperature changes. The sensor must be assigned to the cover so that it can
process the measured values of the sensor. This assignment is done via the app.
￭
Select "Add sensor" in the app configuration.
An input field for the MAC address of the device will appear in the app.
￭
Enter the MAC address (3) in the input field.
The actuator will now evaluate all received sensor telegrams.
4
Mounting
Remove empty batteries immediately and dispose of in an environmentally friendly
manner. Do not throw batteries into household waste. Consult your local authorities
about environmentally friendly disposal. According to statutory provisions, the end
consumer is obligated to return used batteries.
Selecting installation location
To ensure good transmission quality, keep a sufficient distance from any possible sources of in-
terference, e.g. metallic surfaces, microwave ovens, hi-fi and TV systems, ballasts or trans-
formers.
3 / 5
82599913
11.11.2019
J0082599913
