picture 5
o
Fasten repeater with 2 screws (6).
o
Break out cable entry (10) and insert mains cable (9).
o
Connect mains cable to the repeater.
o
Teach transmitter into repeater (see Commissioning chapter).
o
Fasten housing lid with screws.
Routing the antenna out of the housing
i
Only permitted with protection rating IP 20.
If the radio reception capability of the repeater is not sufficient, it can be improved by routing out
the antenna that is rolled up in the device.
o
Slacken screws (5) and remove housing lid (4).
o
Break out cable entry (7).
o
Route antenna (8) out.
o
Fasten housing lid with screws.
4.2 Commissioning
Teaching a radio transmitter
In order for the repeater to transmit the radio telegram of a transmitter, this transmitter has to be
taught into the repeater.
While a transmitter is being taught the range of the repeater is reduced to approx. 5 m. The
distance between the repeater and the transmitter being taught should therefore be between
0.5 m and 5 m.
o
Turn
Prog
switch (11) to the
ON
position (picture 5).
The red Prog LED (2) flashes (picture 1).
o
Trigger teach telegram on radio transmitter (see instructions for radio transmitter).
The radio transmitter has been taught. The green and red LEDs light up as an
acknowledgement.
i
When the radio transmitter is taught, all of the channels that are present, the All On, All Off
and the light scene buttons are also taught.
o
Turn
Prog
switch (11) to the
OFF
position.
Both LEDs go out.
4/6
32530513
J:0082530513
20.07.2010
Radio Management
Repeater
