Jumpking JumpPOD, User Manual

Page: 16 / 22

16
Black webbing with yellow line
No yellow line
3
Frame
V-ring
10
12
22
10
V-rings Top Holes
Frame
Yellow Webbing Location
Yellow Webbing Location
Yellow Webbing Location
Yellow Webbing Location
3. Lay the Bed (10) on the ground inside of the
assembled frame. Make sure that the two warn-
ing decals (not shown) are on top of the Bed.
Note: There are V-rings around the edge of the
Bed (10) and holes around the top of the frame.
During this step, you will attach the Bed to the
frame using the included Springs for holes on top
of frame (see the inset drawing). Hook a spring to
the Bed(10) and using the spring pulling tool(22),
pull the spring from the Bed to the hole slot in the
trampoline frame with even spring tension.
To attach each Spring, you will first hook one end
of the Spring into a V-ring with yellow webbing
location (see the inset drawing).
Hook the first two Yellow color Spring(12) into two
the V-rings (black webbing with yellow threads) on
the Bed(10) and into the holes on the POD-
Connector(4). Attach two more Yellow Springs(12)
with black webbing/yellow threads location directly
across the Bed (with the webbing) from the first two
Spring. Attach two more Yellow color Spring(12) with
black webbing/yellow threads location halfway
between the first/second Yellow color Spring(12),
so eight Yellow color Springs(12) are attached as
shown. Attach four more Springs(11) (not shown)
halfway between the first eight Springs(11).
Continue attaching Springs (11) halfway between
the previously attached Springs, until all the Springs
are attached.
During the installation of springs, wear
gloves and protective eye wear
Spring (11):
Spring(12):
(
Yellow Color
)
Hook the V-ring
Hook the V-ring