User's Guide _______________________________________________________________________
74 _______________________________________________________________________________
Table 12
Communication Settings for the Service Port
Parameter
Value
Bauds
19200
Parity
None
Data bits
8
Stop bits
1
Flow control
None
For a detailed explanation of using a terminal program, see
section Terminal Program Settings on page 76.
4.
Power-up the transmitter.
LAN Communication
To enable LAN communication, a LAN or WLAN interface must be
physically connected to the network, and the networking settings must
be suitable for your network. For a description of interfaces, see
sections LAN Interface on page 55 and WLAN Interface on page 56.
The LAN and WLAN interfaces both operate by accessing the serial
interface (User Port) of the transmitter. All commands that are
available using the serial interface are available through the LAN and
WLAN interfaces; refer to section List of Serial Commands on page
85. For instructions on how to connect using a terminal program, see
section Terminal Program Settings on page 76.
IP Configuration
The IP settings of the LAN and WLAN interfaces are described in
Table 13. The current settings can be viewed on the serial line or using
the device information display; see section Device Information on
page 99.
