Chapter 3 ________________________________________________________________ Installation
JUMO __________________________________________________________________________ 57
Hyperterminal. When the WLAN Interface is in use, serial
communication using the User Port is disabled.
Similarly to the LAN Interface, the WLAN interface can use both
static and dynamic network settings. If the interface is configured to
use dynamic settings, the network where the WLAN interface is
connected must have a DHCP server that provides the settings.
The WLAN interface also provides a web configuration interface,
which you can access by entering the IP address of the WLAN
interface in the address field of a web browser.
0802-103
Figure 36
WLAN Interface Module
The following numbers refer to Figure 36 above:
1
=
Flat cable connector
2
=
Connector for antenna cable (connected to transmitter cover)
Attaching the WLAN Antenna
The LAN interface module must be installed at the factory (when
ordering the transmitter. Before taking the transmitter into use, the
user must attach the antenna of the WLAN interface into the RP-SMA
connector on the transmitter cover. The location of the antenna is
shown in Figure 74 on page 159.
Data Logger Module
The optional data logger module extends the data storage for the
measurement data. When the data logger is present, this storage is
automatically used by the transmitter. The stored data can be browsed
