
Setting of temperatures
Example: Adjustment/modification of the pre-setting of
"SETPOINT 3"
1. Press the
key.
2. Select SETPOINT 3 by pressing the
key.
Example: SETPNT 3 / 70.00 °C
3. Keep the
key pressed until the integer digits flash .
(example: <70>)
4. Adjust value by pressing the
key and the
key to 85.00 °C
and confirm by pressing the
key.
The decimal digits flash and can be adjusted if desired.
Confirm once more by pressing the
key.
Example on the left: SETPNT 3 / 85.00.
If the active setpoint (SETPNT) is changed, the new value is
immediately used for the control of the working temperature.
The heater control indicator flashes.
If the other two setpoints (not activated for control) are changed the
MENU has to be left by pressing the
key after the decimal
digits have been confirmed
Notice: Refer to SETPOINT MAX / MIN in chapter
7.2.
Direct setting of temperatures
The circulator uses the setpoint of SETPNT 1 or 2 or 3 for temperature
control
The indicated setpoint temperature can be changed directly any time.
Example: change 25.00 °C to 50.00 °C
1. By pressing the key
the circulator switches to the active
SETPOINT< example on the left: >SETPNT / 1 25.00°C<.
The integer digits flash (example: <25>).
2. By pressing the keys
and
the value is changed to
50.00 °C and
is confirmed by pressing the
key.
The decimal digits flash and can be adjusted if desired.
Confirm once more by pressing the
key.
The circulator uses the new working temperature value for temperature
control.
The temperatures can be set in start or stop mode.
24