Operation
51
4. Use the arrow keys to select the menu option
<
bb> and confirm with
[OK]
.
5. Use the arrow keys to select
<YES>
and confirm with
[OK]
.
The display flashes briefly. -bb- is shown on the display when saving.
The blackbox data is saved onto the USB stick as a .txt file.
8.7 Adjust pump
The performance of the pump can be set in one-percent increments.
The device is switched on.
1. Press the
[MENU]
key.
2. Use the arrow keys to select the menu option
<Pu>
and confirm with
[OK]
.
3. Use the arrow keys to set the motor speed between 30% and 100% and
confirm with
[OK]
.
The setting is applied immediately.
The pump is set.
To achieve low setpoint temperatures, it may be helpful to reduce the pump
output in certain situations. This decreases the pump's heat input into the bath
fluid.
8.8 Remote control device
The device can be connected to a PC via its interfaces and controlled remotely
using a program such as ° EasyTemp. It is also possible to send interface
commands to the device using a terminal.
The respective interface is set up when the remote control is deactivated.
If remote control mode is enabled, the device cannot be operated directly.
8.8.1 Remote control device using USB interface
The device can be remote-controlled via the standard USB B interface.
The device is switched off.
The computer has a terminal program installed.
1. Connect the circulator (USB port type B) to the computer with a standard
USB cable.
2. Download the suitable USB driver from the download area of the website
www.julabo.com.
Depending on the operating system used by the connected computer, it may
be necessary to install the USB driver.
3. Install the USB driver on the computer.
Summary of Contents for CORIO CP-1000F
Page 72: ......
