EN
43
Warm start
Do as follows to start a warm engine:
1. Put the engine switch in the ON position.
2. Press the primer bulb 10 times.
3. Put the choke lever in the open position
and pull the starter cord until the engine
starts.
Switching off
Normal switching off
To switch off the engine move the throttle lever
to idling mode and put the engine switch in the
OFF position.
Emergency stop
Put the engine switch in the OFF position to
switch off the leaf blower immediately in an
emergency situation.
HOW TO USE
• Only use the leaf blower in daylight, or in
good artificial lighting.
• The leaf blower should be used with lowest
possible engine speed necessary to do the
work.
• Carefully inspect the area where the leaf
blower is to be used and remove any
foreign objects.
• Hold the blower nozzle just above the
ground and sweep the blowpipe from side
to side while moving forwards, pointing the
nozzle at the material to be removed.
• Never point the blower at people or
animals.
WARNING!
Make sure that removed material does not
cause personal injury and/or material damage.
Never point the air flow at people or animals.
Never point the air flow into the wind.
Blower function
IMPORTANT:
• Always keep a firm grip with your right
hand in the top handle when working.
• Adjust the engine speed to the material to
be removed.
1. Use a low engine speed for light material
and small twigs on grass.
2. Use a medium engine speed for grass and
leaves on a hard surface.
3. Use a high engine speed for heavier
material, such as newly fallen snow or piles
of leaves.
WARNING!
• Make sure that removed material does
not cause personal injury and/or material
damage.
• Never point the air flow at people or
animals. Never point the air flow into the
wind.
Suction function
IMPORTANT:
• Always hold the machine firmly with both
hands when working.
• Hold the top handle with your left hand
and the bottom handle with your right
hand, with the bag to the right of your
body.
The suction function works best at medium/high
speed. Keep the round end of the tube a few
centimetres over the ground when working. The
bag functions as a filter, in the same way as a
normal vacuum cleaner.
1. Make sure that the bag hangs freely and
that the strap does not get twisted.
2. Do not fill up the bag completely full.
3. Switch off the engine.
4. Open the zip and empty the bag without
Summary of Contents for Meec tools 003854
Page 4: ...1 1 2 4 3 5 7 8 9 10 6 11 12 13 14 15 16 19 18 17 21 22...
Page 5: ...2 3 4 5 6...
Page 6: ...7 8 9 11 10 12...
Page 7: ...13 14 15...
