EN
11
Assembly instructions
The following tools are needed for assembly:
drill, screwdriver and spirit level.
1. Start by planning where the railing is to
be placed, and ensure that it is level.
2. Lift up the glass plate. The end with
predrilled holes in the aluminium edging
should face upwards.
3. Place the glass plate between two posts
and drill two holes in each post with the
supplied drill.
FIG. 7
4. Fasten the glass plate in the posts with
the four supplied screws.
5. Mark where the four holes are to be
drilled to fasten the foot of the post.
Move the railing and drill holes in the
surface with a Ø 12 mm drill.
FIG. 8
6. Fasten the posts with screws (sold
separately) and continue in the same way
with the next section until the complete
railing is assembled.
NOTE:
Use the right screws, depending on the
surface material. Use Ø 11.5 mm concrete
screws for a concrete surface. Use Ø 11.5 mm
French wood screws for a wooden surface.
Screws sold separately.
7. Fit cover strip to conceal the slot in the
high post if it is connected to a lower
section of the railing.
FIG. 9
MAINTENANCE
Glass
Use a soft cloth, water and window cleaner.
Only use a mild detergent. Strong or caustic
detergents will damage the glass.
SAFETY INSTRUCTIONS
• The product is only intended to be
assembled outdoors.
• The maximum installation height above
ground is 100 centimetres.
• Replace damaged glass plates
immediately.
NOTE:
Note the wind tolerance table for glass
railing.
DESCRIPTION
Assembly parts needed for installing the railing:
1. Glass plate
2. End post
3. Corner post 90°
4. Middle post 180°
5. Middle post 135°
6. Screw M3.5 x 12 mm
7. Drill Ø 3 mm
FIG. 1
FIG. 2
FIG. 3
FIG. 4
FIG. 5
NOTE:
All assembly parts such as glass plate, corner
post, middle post and end post are sold
separately.
ASSEMBLY
Suggested assembly
FIG. 6
Summary of Contents for Hard Head 010515
Page 3: ...7 8 1 2 6 6 1 2 3 4 5 5 4 3 7...
Page 4: ...9...
