12
INSTALLATION
1.
Do not install the product on surfaces that
are exposed to vibrations.
2.
The product should be mounted with the
wall bracket. The product must only be
installed as shown in the diagrams. It must
not be installed with the ventilation hole
pointing up.
3.
Mark out the holes for the wall bracket, drill
the holes and insert plugs. Fit the wall
bracket
with
suitable
screws
(not
included).
4.
Open the lamp cover.
5.
Insert the mains cable (not supplied, use cable of H05RN-F 3G 1.0 mm
2
type) in the lamp housing
through the grommet with rubber seal. Check that the grommet is sealed.
6.
Connect the power cord wires.
NOTE:
A damaged power cord should be replaced by an authorised service centre, or qualified person, to
ensure safe use.
Installation height 2.3
–3 m (out of reach).
Neutral wire, lamp
Blue (neutral wire, mains)
Yellow-green (earth
wire, mains)
Brown (live wire, mains)
Input
Black (PIR)
Neutral wire, lamp
Green-yellow (neutral
wire, lamp)
Brown (PIR)
Brown (live wire, mains)
MOTION DETECTOR
