ENGLISH
30
NEVER leave the battery unattended
when charging.
OPERATION
Use
Step 1: Activate the remote control. The status
light on the remote control flashes rapidly blue.
Step 2: Insert the battery in the quadcopter. The
quadcopter’s status light flashes slowly red.
Step 3: When the status light flashes, put the
quadcopter on a level surface.
Step 4: Push the lever to the top position and then
back to the lower position. Both status lights are on.
NOTE:
1.
If the remote control does not find the helicopter’s matching code in 30 seconds after starting, switch
off the remote control and start it again.
2.
If the LED indicator flashes slowly after starting the remote control and the helicopter, this means
that the matching code was not found. Repeat the above steps again.
3.
The quadcopter must be in a horizontal position when the codes are matched, otherwise both the
quadcopter and the remote control must be switched off and matched again.
Summary of Contents for 960-197
Page 35: ......
