ENGLISH
24
Fitting the ejector guard
Turn the trimmer upside down and fit the safety guard.
Fitting the trimmer head
1.
Push the rear flange on the spindle head
and secure the trimmer head.
2.
Block the spindle head as described
above.
3.
Tighten the trimmer head securely.
OPERATION
Fuel
Use standard unleaded petrol mixed with 2-stroke engine oil in the ratio of 40:1 for best results. Use the
mixing ratio shown in the FUEL MIXTURE below.
WARNING!
Never use unmixed petrol in the machine. This can cause permanent damage to the engine and
void the manufacturer's warranty. Never use fuel mixtures that have been stored for more than 90
days.
The 2-stroke oil must be top-quality oil for 2-stroke air-cooled engines and mixed in a ratio of 40:1.
Mixing the fuel
Add the oil in an approved fuel container and then pour in the petrol to ensure that the petrol and oil mix
well. Shake the container to mix the oil and petrol.
WARNING!
The manufacturer's warranty will become void if there is inadequate lubrication. The petrol
and oil must be mixed in a ratio of 40:1.
Recommended fuel
The engine is designed to function well with any type of petrol intended for cars, including petrol with
additives.
Starting a cold engine
1.
Set the ignition lock to RUN (I).
2.
Press the primer about 10 times.
3.
Locking the throttle control lever. Press in the throttle control lock button, set the throttle control to
full throttle, press in and hold in the lock button. Release the throttle control lever. The throttle
control now stays in fully pressed position (full throttle).
4.
Set the choke in the choke position.
5.
Pull the starter cord about 10 times.
6.
Set the choke in the middle position.
7.
Pull the starter cord until the engine starts.
8.
Give the engine time to warm up and then set the choke to "OFF".
Starting a hot engine
If the engine has not been turned off for more than 15–20 minutes.
1.
Set the ignition lock to RUN (I).
2.
Lock the throttle control lever.
3.
Pull the starter cord until the engine starts.
Summary of Contents for 723-076
Page 28: ......
