ENGLISH
8
ENGLI SH
SAFETY INSTRUCTIONS
Electrical installations must only be carried out by an authorised electrician.
Switch off the light and wait until it has cooled before replacing the fluorescent tube.
Do not touch the fluorescent tube when the light is switched on.
Switch off the power supply to the light immediately in the event of a malfunction. Do not attempt to
repair the light yourself. Repairs must only carried out by qualified personnel or an authorised
service centre.
The earth wire must be properly connected.
ELECTRICAL SAFETY
New installations and extensions to existing installations must always be carried out by an authorised
electrician. If you know what you are doing (otherwise contact an electrician) you may replace switches
and wall sockets, and fit plugs, extension cords and light sockets. Incorrect installation can result in fatal
injury and fire hazard.
TECHNICAL DATA
Rated voltage
230 V ~ 50 Hz
Output power
2 x 36 W
Protection rating
IP30
Safety class
I
Fluorescent tube
T8
INSTALLATION
Electrical installation
1.
Switch off the power supply before installation. Unscrew the screws.
2.
Remove the cover.
3.
Screw the frame to the ceiling.
4.
Connect the three wires in the power cord to the matching terminals. Connect the brown live wire
(L) to the brown terminal, blue neutral wire (N) to the blue terminal and green-yellow earth wire
(
) to the green-yellow terminal.
5.
Insert the fluorescent tube.
6.
Replace the cover and screw tight.
7.
Switch on the power supply.
NOTE
Minimum cable cross-section area 0.75 mm²
1.
Brown live wire
– L
2.
Yellow-green earth wire
–
3.
Blue neutral wire
– N
