ENGLISH
11
ENGLISH
SAFETY INSTRUCTIONS
Read these instructions carefully before use!
Save these instructions for future reference.
Make sure that air is able to circulate freely around the transformer. It can become hot during use.
The mains power supply must have a residual current device with a maximum tripping current of 30
mA.
Make sure that the mains power supply is turned off before installation.
Do not tamper with or make any adjustments to the ON/OFF switch.
Do not make any modifications to the internal wiring and/or connections.
Repair work must only be performed by an authorised service centre.
The LEDs cannot be replaced.
The light fitting must not be dismantled. The LEDs can cause damage to the eyes.
For safety reasons, the power cord must only be replaced or repaired by an authorised service
centre. Consult your dealer.
Special safety instructions
Please refer to the product label for information on which zone the product may be installed.
The electrical circuit must be protected with a 10 Amp fuse.
The product must not be installed in the grey zones (see figure).
The product may only be installed on the ceiling if the ceiling is closed.
Check that the cables are long enough for your installation plan.
Only use accessories recommended by the dealer.
Do not connect additional spotlights to the transformer.
TECHNICAL DATA
Transformer 6
VA
Bulb LED
Colour temperature
3000 K
Output
3 x 2 W
Protection rating
IP44
INSTALLATION
The product must not be installed in the grey zone (zone 0 and 1).
